How do I install my 30ft 120 volt telescopic mast?

1. Remove shipping material and hardware boxes from the unit.

2. Remove the cotter pins on each leg and extend until they can be reinstalled in the deployed position through holes.
   

3. Using the jack crank adjust, jack heights until the entire unit is level—refer to the bubble level located at the base of the mast. Return the jack cranks to the storage box for safe keeping.
   

4. Remove the 4 bolts from the bottom of the camera mount. Center the plate of the camera mount on the top of the mast and return the bolts to secure the mount.
   

5. Mount your camera:

   1. For Sapphire Video-pan-tilt-zoom: Remove lid screw and base bolts to disassemble camera mount.
      
      

      Screw the base onto the camera plate being careful not to pinch the ethernet cable. Return the cap to its base.

       
   2. For Sapphire Static: Secure camera around pole with the provided band clamps fed through the slits on either side of the camera plate.
   3. For Cobalt: Screw your camera into the knuckle at the top of your camera mount. Adjust the angle of the camera to face your jobsite.
6. Plug in your camera: 

   1. For Sapphire Series cameras only: Plug the camera ethernet cable and main power cable into the power box. Rest the cable of the camera loose on the ground so it doesn’t get pinched or tangled while raising the mast.

      Ensure the system is on via the blue light on the bottom of the power box. Call your Customer Service rep to verify proper installation. Have the camera ID located on your camera ready for verification.

   2. For Cobalt camera: Plug camera cable into your main power source then, ensure your system is on via the blue light at the bottom of the camera.

7. Carefully separate braided cables of tether assemblies (being sure not to tangle or kink) then clip the carabiners on to the 4 eyelets of the mast.

8. With the silver mast crank, extend the mast until the internal segments clear the lockout holes.
   

9. Remove the mast locking pin keys from the lockbox on your mast—code is located on the brochure sent with your mast. Unlock the mast locking pin.

10. Insert the mast locking pin with the lock side on the center of the mast then lock the pin. Return the keys to the lockbox.
    

11. To minimize cable load, crank the mast back down until the locking pin no
    longer moves and return the crank to the storage box.

12. With turnbuckles of each tether assembly extended to their full capacity, fasten each to the anchor points on the jacks. Be sure each tether assembly is attached to the corresponding mast leg.
    

13. Tighten each turnbuckle until tether assemblies are evenly taut. Do not over torque.

14. Ensure all cranks are secured in the storage box and to tamper proof your system, place all keys are in the lockbox. Zip-tie the camera cables in an orderly fashion off the ground to avoid disturbance.