How do I install my security camera system?

1. Mount the talk down hardware to the security cabinet with two screws.

2. With two bolts, remove the hanger mount from the security cabinet. Use three provided band clamps to secure the hanger mount to the pole where the top of the cabinet will go.

3. Hang the cabinet on the mount and replace bolts. Use one additional band clamp to secure the bottom of the cabinet to the pole.

4. Place battery in the security cabinet and connect its positive cable first then its negative cable.
   

5. Mount your camera:
   
   1. For Sapphire Static: Secure camera around pole with the provided band clamps fed through the slits on either side of the camera plate.
   2. For Sapphire Video-pan-tilt-zoom: Remove lid screw and base bolts to disassemble camera mount.
      
      Band clamp camera plate to pole with the arrow facing up.
      Then, reassemble camera mount by attaching base bolts to the camera plate and then close the system with the lid screw. 
6. To confirm installation is complete, send photos of (1) the complete installation and (2) the charge controller reading to OxBlue Support at oxbluesupport@oxblue.com ­— use the 6-digit ID found on the back of the camera as the email’s subject line.